LAB-2250  (420-2921)             Operation             Faxback Doc. # 6262

USING AUTOMATIC PLAY

  1.  Set your receiver/amplifier's volume control to a low level.  Then,
      set its input selector to PHONO and turn on the receiver/amplifier.

  2.  Press [POWER] on the turntable.  The SIZE 12 indicator and the SPEED
      33 indicator lights.

  3.  Lift the dust cover and pull the stylus cover toward you to remove
      it.

  4.  If necessary, press [SIZE] to select the 7 inch size.  The SIZE 7
      indicator lights and the SPEED indicator changes from 33 to 45.

NOTE: This turntable is designed to play only standard-size records.

  5.  Place a record on the turntable and close the dust cover.

  6.  Press [PLAY/STOP].  The turntable starts, and the tone arm lowers
      itself onto the record.

At the end of the record, the tone arm automatically lifts and returns to
the tone arm rest, and the turntable stops.

At any time during the play cycle, you can gently lift the tone arm from
the record by pressing [CUE].  The table continues to rotate.  Press [CUE]
again to lower the tone arm and resume the play cycle.

To stop the play cycle before the end of a record, press [PLAY/STOP].  The
tone arm lifts and returns to the tone arm rest, and the turntable stops.

POWER FAILURE PROTECTION

This feature protect the turntable's stylus and the records in case a
power failure occurs.  If the power fails, the tone arm automatically
raises.  When power is restored, the tone arm returns to the tone arm
rest.

NOTES: Do not touch tone arm while it is moving.

       When you play a 45-rpm record with a large center hole,
       place the supplied adapter over the turntable spindle.

USING REPEAT PLAY

  1.  If you want to repeat a side of a record [REPEAT].  The
      REPEAT indicator lights.  When the tone arm reaches the end of the
      record, it returns to the beginning of the record and plays the
      record again.

  2.  To stop repeat play, press [REPEAT] again.  The REPEAT indicator
      goes off.

USING MANUAL PLAY

  1.  Follow Steps 1-5 of "Using Automatic Play."

  2.  Press and hold [ << ] or [ >> ] to select the desired part of the
      record.  The tone arm moves to the left or right.

  3.  Press [CUE].  The tone arm lowers and play begins at the selected
      location.

(CJD/smc-05/19/94)