VGM-150  (25-4090)   Automatic Software Installation   Faxback Doc. # 6076

Follow these procedures to install the full-page utility programs onto 
Drive A for floppy-disk systems or Drive C for hard-disk systems.

To Install the Drivers on Drive A:

1. Boot your computer.
2. Place the DRIVERS disk in Drive B. If you have only one floppy disk 
   drive, use for both Drive A and Drive B.
3. Type: B: to make Drive B the current drive. Press <ENTER>.
4. Type: installf press <ENTER>.
5. Follow the displayed instructions.

To Install the Drivers on Drive C:

1. Boot your computer as usual.
2. Place the DRIVERS disk in Drive A.
3. Type: A: to make Drive A the current drive. Then, press <ENTER>.
4. Type: installh and press <ENTER>.
5. Follow the displayed instructions.

Manual Software Installation:

Follow these steps to manually install the software.

Note: Manual installation requires some knowledge of MS-DOS commands and 
procedures.

1. Copy FP.SYS from the DRIVERS disk into the boot disk's root directory or 
   into a subdirectory.
2. Copy FP.EXE from the DRIVERS disk into any directory that is in the DOS 
   path.
3. Add the following statement to your CONFIG.SYS file:

   DEVICE="path"\FP.SYS

   where "path" is the subdirectory you copied FP.SYS into in Step 1.

4. If your CONFIG.SYS file contains any other statements that load screen
   device drivers, such as DEVICE=ANSI.SYS (the DOS screen driver), remove 
   all such statements so that FP.SYS operates correctly.
5. Reboot your computer so the configuration change can take effect.