CGP-220  (260-1268)          Papaer Loading            Faxback Doc. # 5805


The CGP-220 uses either Single-sheets (260-1341) or Roll-Paper (260-1333).

SINGLE-SHEET PAPER LOADING

1. Turn the power OFF.
2. Move the Paper Release Lever forward.
3. Insert a sheet of paper into the Paper insertion l=slot at the end of the
   Paper Cover.
4. Push the Paper Release Lever toward the rear and turn the Manual Feed 
   Knob to pull the paper around until it feeds about 4" above the Paper 
   cutter.
5. Pull the Paper Release Lever forward again to align the paper, then push 
   it toward the rear.
6. Turn the Paper Feed Knob to return the paper to the desired printing
   position.
7. Turn the power ON.

After the paper is loaded and the power id ON, check the ALERT Indicator. 
If it is illuminated, press the RESTART. If it turns off you may put the 
Printer ON LINE and begin printing. If the Indicator remains lit the paper
is probably loaded incorrectly.

Once the paper is properly loaded, printing will continue until the paper's
bottom edge passes a "paper empty sensor." When this happens, the CGP-220 
will go OFF LINE and the ALERT Indicator will begin flashing. You should 
then insert another piece of paper and press the RESTART Switch. The 
CGP-220 will resume printing from where it left off.

NOTE: Be sure to set the Paper Release Lever toward the rear after the paper
is loaded to avoid a paper jam.

ROLL-PAPER

1. Be sure the power is turned OFF.
2. Open the Paper Cover. Press the Roll-Paper Holder toward the left. Insert
   the right end of the Roll-Paper into the circular projection on the right
   side, and then release the Roll-Paper Holder to secure the other end of the
   Roll-Paper.
3. Pull the Paper Release Lever forward.
4. Insert the Paper into the Paper Insertion Slot.
5. Push the Paper Release Lever toward the rear and use the Manual Feed 
   knob to pull the paper around until it appears between the platen and the 
   Paper Cutter.
6. Pull the Paper Release Lever forward again to align the paper, then push it
   toward the rear.
7. Turn the Manual Feed Knob to return the paper to the desired printing
   position.
8. Close the Paper Cover.
9. Turn the power ON.

After the paper is loaded and the power is ON, check the ALERT Indicator. 
If it is illuminated, press RESTART. If it turns off, you many put the Printer
ON LINE and begin printing. If the Indicator remains lit the paper is probably
loaded incorrectly.

NOTE: Be sure to set the Paper Release Lever toward the rear after the paper
is loaded to avoid a paper jam.

SETTING THE GREEN LEVER

The Green Lever performs three primary functions:

1. It lets you lack the carriage and cap the ink nozzles. This protects the
   Printer from vibrations during transportation and prevents the ink from
   drying or spilling.
2. It unlocks the carriage and uncaps the nozzles to permit printing.
3. The Green Lever can also be used to "pump" the ink supply to provide better
   printing quality.


(smm 08/04/93)