DWP 230  (260-2812)         Paper Loading              Faxback Doc. # 4802

You can use either fanfold computer paper or single-sheet typewriter paper
with the DWP-230.

If you're using fanfold paper, you'll find it most efficient to use the
optional/extra DWP 230 Bidirectional Tractor feed unit (26-2813).

SINGLE-SHEET PAPER LOADING (FRICTION FEED)

1. Gently pull the paper bail away from the platen.

2. Set the platen pressure lever toward the rear side of the Printer 
   (pressure ON).
3. Insert the paper behind the platen and turn the platen manually (turn 
   the paper advance knob) so that the paper advances past the card guide.

4. Set the platen pressure lever toward the front of the Printer (pressure
   OFF) so that the paper can move freely back and forth.

5. Align and position the paper at the left margin.

6. Hold the paper in position and move the platen pressure lever back to-
   ward the rear side of the Printer (pressure ON). The paper will no 
   longer move freely.

7. Lower the paper bail so that it is against the paper.

8. Position the paper manually to the first line of printing by turning the
   paper advance knob.

NOTE: If the Printer runs out of paper, no out-of-paper signal will be sent to
the computer; the Printer will continue printing on the platen. If this
happens, immediately turn the ON LINE/OFF LINE switch to OFF LINE; after
loading more paper, return this switch to ON LINE to resume printing.

(dtc-07/27/93)